It seems the insertion point of the block wants to be nowhere near where the geometry? It's tremendously obnoxious if you want the block you create through FLATSHOT to be close to the geometry in model space. Once you finally figure that out, you left-click to place it, then scale and rotate it as with a normal block insertion.Ħ. So, you have to zoom way out to see where it actually is to be able to locate it where you want.ĥ. (As a corollary, I'd really like to know why this would ever happen).Ĥ. It doesn't appear AT the crosshair, it's somewhere else relative to it. A block appears in a weird location at some seemingly arbitrary distance from the crosshair. In this instance I guess it's fine to just consider blocks created through the FLATSHOT command.Įxploding a block, or using a block editor, would not work, because in my example the block hasn't been placed yet.ģ. I don't understand how what's happening now would ever be useful.Īnyway, am I just missing some obvious system variable, or something? You can enter the information for steps 3, 4, and 5 into the Block Definition dialog box in any order. In my mind, either a block is always inserted at the origin (or another specified point), or it's inserted at the crosshair. I don't get why this would ever be the case. Consider the following: Ensure the Insertion Units matches that of the Block. Block is not Annotative to match the Units of the drawing. Insertion Units do not match the Block formatting. So, if my geometry is far enough away from the origin, I have to zoom way out after creating the block just to be able to see where it is and be able to locate it with a final left click. Placing block from tool palette does not scale properly in AutoCAD. It's not AT the origin, it's at a certain distance away from the crosshair. how do I explain this? It's the same distance from the crosshairs as the origin was when the block was created. The resulting block always has an insertion point of. So, I orient the camera, and use the FLATSHOT command. Say I have some geometry that I want a 2D block of. Sorry if I'm missing a thread and this is a duplicate. In addition to the daily activities of the support center, he helps write for the National Support Center blog, and has written online classes for the IMAGINiT training on demand site.I'm going to sound dumb here, but I can't figure this one out using the normal Googly avenues. The geometry was originally drawn at the wrong scale. This may occur with any object, including: Geometry Block Xrefs Vehicle Tracking object Raster image The drawing might be set up in different units than expected. Manufacturing Solution Center Team LeadJeff is responsible for manufacturing Technical Support for both internal staff and customers. When inserting an object into an AutoCAD drawing, the object is inserted at the wrong scale, or displays at the wrong scale when measured. Open External References and Copy/paste to new files and then recreate Layer States that are needed.Make sure the Status has changed to Included and the Add button becomes Remove. Clear temporary files to free up memory. In the Autodesk AppModeDeployment Updates dialog box, click UPDATES, and then the Add button to the Service Pack 1 that you want to add.Close AutoCAD and then relaunch to clear memory. Install Object Enablers if you are using a file from a vertical add-on such as Civil 3D, Architecture, etc.Install the tested and supported Video Card Driver from (If not listed you can try using the latest driver).Scaling from Model Space to Paper Space is not the same.Too Much data selected (There is a memory limit to Copy/Paste).This can cause crashing with Fatal errors. When using Copy/Paste in AutoCAD the command either takes a very long time to Paste or does not work at all. AutoCAD: Copy/Paste taking a long time or not working.
0 Comments
Leave a Reply. |